TriPoint VertexRSI 7200, Руководство по эксплуатации и обслуживанию

Страница: 192 / 266

A ppend i x C - 7 2 0 0 Remote Mon i tor and Contro l Protoco l C G-6 0 4 2 (Rev. F, June 2 0 0 0)
C - 2 8
C318 n " Reset OPT target " i s used to c l ear the target’s stored steptrack data
and orb i ta l e l ements. Th i s i s used i n the event that OPT comes up w i th
bad so l ut i ons and i s unab l e to track proper l y. " Reset OPT target " does
not affect any of the spacecraft, steptrack, or OPT parameters.
Funct i on: Reset OPT target
n = target number of a va
li d OPT mode target
i f n = 0 then reset the current OPT target under track.
Th i s has the same effect as se l ect i ng the target number of
the current target i n track.
Response: < none >
Secur i ty: Operator ( l eve l 2)
C319 n Funct i on: Stops and resumes track i ng i n OPT mode on l y.
Does not cause a l arm cond i t i on and has no effect
on other modes.
n = 0 S i m il ar to act i on of [ST OP] key but cou l d have de l ay
to a ll o w comp l et i on of current steptrack cyc l e. The ho l d i s
not i n effect unt il the " Track i ng ho l d i n i t i ated by M&C "
submode (2 5) i s set. Check submode w i th R7 request.
n = 1 C l ears " Track i ng ho l d i n i t i ated by M&C " submode
and a ll o w s system to cont i nue operat i on. Ho l d can a l so be
c l eared by tak i ng system to ST A NDBY or restart i ng the
target.
Response: < none >
Secur i ty: Operator ( l eve l 2)