Toshiba VP 300, Руководство по установке

Страница: 45 / 614

CHANGES TO THE PHONE SYSTEM
Changes may be required to the following:
•
The VP 300 port extensions
•
Called extensions
•
Trunks
– Redirection
– Selection
Additional equipment may be required before these changes can be made. Most changes are to the PBX
database.
■
The VP 300 Port Extensions
Connect and configure the port extensions using the following steps:
1. Designate one 2500-type, single-line, touchtone extension for each VP 300 port. Additional PBX
line circuits may be required.
2. Terminate each of these extensions to a 66M connector block, or equivalent. Clearly mark each
termination point with the extension number.
3. Assign a PBX class of service to these extensions permitting them to:
•
Initiate calls
•
Receive (incoming) calls
•
Place calls on hold
•
Transfer calls
•
Forward calls
4. Remove any type of call waiting features from the VP 300 port extensions.
☞
If configuring ports for outcalling to network locations for off-site message notification or
for off-site alarm calls, make sure the port extensions are
not restricted from making calls
to these locations (e.g., toll restriction).
5. Set up a hunt group for each group of port extensions configured to answer in the same way
(company greeting, intercept position, mode). Where possible, make these circular hunt groups.
☞
In cases where the PBX queues call to a busy hunt group and no overflow position can
be defined, you may want to set up a “terminal” hunt group with the attendant, if possible,
or other intercept position as the last member of the hunt. When all the VP 300 ports are
busy, calls hunt to this last member of the group for answer.
Toshiba VP Systems Release 6.1 February, 1993
PREPARING THE PHONE SYSTEM 2-7
2.4