Toshiba TOSVERT VF-PS1, Инструкция по эксплуатации

Страница: 129 / 317

E6581531
F-14
6
ON
OFF
Time [s]
DC braking start frequency
H
DC braking current
H
DC braking time
H
Output frequency [Hz]
DC braking
Operation signal (F-CC)
Output current [A]
0
0
Set frequency
Note:During DC braking, the DC braking
current may be adjusted
automatically to prevent the overload
protection function from being
activated and causing the inverter to
trip.
The DC braking current may be
adjusted automatically to prevent
tripping.
When the inverter is used with a
standard motor, setting the
percentage of DC braking (
H
)
above 60% may activate the thermal
protection function to prevent the
motor from being overloaded,
depending on the setting of
H
(DC braking time).
LED display
FD displayed
<DC braking start conditions>
The forward/reverse DC braking priority control function H recognizes certain conditions such as stop
commands from the inverter, and is activated when the output frequency goes down below the DC braking start
frequency set with
H
. In this case, the conditions under which DC braking starts include not only the issue of a
start or stop command from the operation panel or an external input device, but also a fall in the reference frequency
below the value set with
H (stop frequency setting) or a fall in the output frequency below the operation stop
frequency setting
H
.
[DC braking under normal conditions] (Forward/reverse run DC braking priority control H = [Disabled])
ON
OFF
Time [s]
: DC braking
H
H
Output frequency [Hz]
Operation signal (F-CC)
Reference frequency
0
0
Set frequency
~~
~~
~~ ~~
~~ ~~
H
H
H H
(1) (2) (3) (2)
(1) If
H and H > reference frequency : DC braking
(2) If H > reference frequency > H : Operation at the command frequency
If
H
and
H
> reference frequency : DC braking
(3) If an operation command is entered during DC braking : DC braking is discontinued to restart the operation.