Toro Reelmaster 5510 Series, Руководство по обслуживанию

Страница: 510 / 662

Installing the Rear Axle (continued)
3. On machines with CrossTrax AWD, do as follows:
g185918
Figure 303
1. Frame bracket 3. Lock washer (3 each) 5. AWD control manifold
2. Bolt (3 each) 4. Spacer (3 each)
A. Raise the CrossTrax AWD control manifold to the frame. Position the
spacers between the manifold and the frame ( Figure 303 ). Secure the
manifold to the frame with the 3 bolts and 3 lock washers.
B. Close and latch the radiator screen assembly.
4. Install the wheel motor housings to the rear axle; refer to Installing the Rear
Axle Motor Housings (page 8–18) .
5. Install the steering cylinder to the rear axle; refer to Installing the Steering
Cylinder (page 6–228) .
6. Install the 2 rear wheel assemblies; refer to Installing the Wheel (page 8–6) .
7. Check the rear wheel toe-in; refer to the Operator’s Manual .
8. Check the hydraulic-fluid level in the hydraulic reservoir and add correct
quantity of fluid if necessary; refer to the Operator’s Manual .
9. Lubricate the rear axle grease fittings.
10. Ensure that there is no contact between the machine components including
hydraulic hoses while the rear wheels move from lock to lock. Adjust if
necessary.
11. Operate the machine and check the hydraulic connections for leaks.
Chassis: Service and Repairs Page 8–22 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C