Toro Reelmaster 5510 Series, Руководство по обслуживанию

Страница: 564 / 662

Assembling the Cutting Reel
1. If the seals and/or bearings were removed from the reel shaft, discard the
components that were removed and replace.
2. Ensure that the 2 retaining rings are fully seated into the grooves on the
cutting reel shaft.
3. If the bearings and seals were removed from the reel shaft, do the following
steps:
A. Ensure that the bore of the seals are clean with no grease or lubricant
applied to the inner diameter of the seal.
IMPORTANT
The grease seal should be installed so that the metal side of the
seal is toward the bearing location.
B. Press the grease seals onto the reel shaft with the metal side orientated
toward the bearing location. Final position of the seal should be flush to
1.5 mm (0.060 inch) away from the retaining ring on the reel shaft. Do not
force the seal against the retaining ring. The seal must be perpendicular
to the reel shaft after installation.
C. Pack the replacement reel bearings with high temp Mobil XHP-222
grease or equivalent.
D. Press grease packed bearings fully onto the reel shaft. The bearings
should bottom on the reel shaft shoulder. Press equally on inner and
outer bearing race when installing the bearings onto the reel shaft.
4. Fill threaded insert splines with high temp Mobil XHP-222 grease or
equivalent.
Cutting Unit: Service and Repairs Page 9–34 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C