Toro Reelmaster 5510 Series, Руководство по обслуживанию

Страница: 635 / 662

Servicing the Groomer Reel
g220506
Figure 399
1. Groomer reel shaft 4. 6.3 mm (1/4 inch) spacer (2 each) 7. Sharp edge
2. Groomer blade (40 each) 5. Locknut (2 each) 8. Midpoint
3. 31.7 mm (1–1/4 inch) spacer (39
each) 6. Centered on shaft 9. Dull (rounded) edge
Inspect the groomer reel blades frequently for any damage and wear. Straighten
the bent blades. Either replace the worn blades or reverse the individual blades
to put the sharpest blade edge forward (
Figure 399 ). The blades that are
rounded to the midpoint of the blade tip must be reversed or replaced for best
groomer performance.
Disassembling the Groomer Reel
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, shut off the engine, set the parking brake, and
remove the key from the key switch.
2. Remove the groomer reel from the cutting unit; refer to Groomer Reel (page
11–13) .
3. If the groomer reel is equipped with broomer kit, remove the straps and
broomer brushes from the reel ( Figure 400 ).
4. Remove the locknut (item 5 in Figure 399 ) from either end of the shaft.
5. Remove the spacers and blades from the groomer shaft. If necessary,
remove second locknut from the shaft.
6. Inspect and replace the components that are worn or damaged.
Assembling the Groomer Reel
Note: New locknuts have an adhesive patch to prevent the locknut from
loosening. If a used locknut is being installed, apply a medium strength
threadlocker (Loctite #243 or equivalent) to the threads of the locknut.
1. Install the locknut on drive end of the groomer shaft. Place a 6.3 mm (1/4
inch) spacer on the groomer shaft followed by the first groomer blade.
Reelmaster ® 5410/5510/5610 Series Page 11–15 Universal Groomer (Optional): Service and Repairs
15216SL Rev C