Toro Reelmaster 5510 Series, Руководство по обслуживанию

Страница: 632 / 662

Installing the Idler Assembly
1. If the shields, bearing, or bushing was removed from the idler arm, install
new components as follows:
A. Press the bushing into a groomer plate until the bushing is centered in
the idler arm bore.
B. Press the bearing into the idler arm so that the bearing contacts the
shoulder in idler arm bore and install the bearing retaining ring.
C. Install the bearing shields with flocked side of shield toward the bearing.
D. Check the idler arm orientation (left or right cutting unit) and insert the
stub shaft (item 8 in Figure 396 ) through shields and bearing. Use the
through hole in the shaft to prevent shaft from rotating, tighten the flange
nut to
37 to 45 N∙m (27 to 33 ft-lb) .
E. If the collar was removed from the idler arm, install the collar and tighten
to 33 to 41 N∙m (24 to 30 ft-lb) .
g220504
Figure 397
1. Pivot hub
2. Apply anti-seize lubricant to the outside diameter of the pivot hub ( Figure
397 ). Position the idler arm over the pivot hub.
3. Apply Loctite to the 2 socket-head screws and secure the pivot hub and
idler arm to the cutting unit side plate.
4. Install a new cotter pin and clevis pin and secure the height adjustment rod
to the front of the idler arm.
5. Install the hydraulic reel motor to the cutting unit; refer to Installing the
Hydraulic Reel Motor (page 9–17) .
Universal Groomer (Optional): Service and Repairs Page 11–12 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C