Toro Reelmaster 5510 Series, Руководство по обслуживанию

Страница: 577 / 662

Servicing the Roller
g195108
Figure 351
1. Roller tube 5. Outer seal
2. Roller shaft
6. Bearing lock nut
3. Inner seal 7. Grease fitting
4. Bearing
Disassembling the Roller
1. Remove the bearing locknut from each end of the roller shaft.
2. Loosely secure the roller assembly in a bench vise and lightly tap one end of
the roller shaft until the outer seals and bearing are removed from opposite
end of the roller tube. Remove the second set of outer seals and bearing
from the roller tube by tapping on opposite end of the shaft. Remove the
shaft from the roller tube.
3. Carefully remove the inner seal from both ends of the roller tube, ensure that
you do not damage the tube surfaces.
4. Discard the seals and bearings that were removed.
5. Clean the roller shaft and all surfaces on the inside of the roller tube. Inspect
components for wear or damage. Also, carefully inspect the seating surface
and threads of the bearing locknuts. Replace all the components that were
damaged.
Reelmaster ® 5410/5510/5610 Series Page 9–47 Cutting Unit: Service and Repairs
15216SL Rev C