Toro Reelmaster 5510 Series, Руководство по обслуживанию

Страница: 315 / 662

Installing the Lift Control Manifold
1. If the hydraulic fittings were removed from the lift control manifold, do the
following:
A. Lubricate new O-rings with clean hydraulic fluid, install the lubricated
O-rings onto the fittings.
IMPORTANT
When installing the orifice in the manifold ( Figure 168 ), ensure
that the orifice is flat in the base of the fitting cavity. Letting the
orifice stay cocked in the cavity can damage the manifold.
B. For the manifold ports with orifice, install correct orifice in the port with
the orifice slot facing out.
C. Install the fittings into the manifold. Torque the fittings to the torque
values identified in Figure 167 and Figure 168 .
2. Position the lift control manifold to frame. Install the 2 flange-head screws
but do not fully tighten.
3. Remove the caps and plugs from the hydraulic lines and fittings.
4. Lubricate and install new O-ring(s) on the manifold fittings. Correctly connect
the hydraulic hoses and tubes to the hydraulic manifold fittings and tighten
all the connections; refer to
Installing the Hydraulic Hose and Tube (O-Ring
Face Seal Fitting) (page 6–11) .
5. Tighten the 2 flange-head screws to secure the lift control manifold to the
frame.
6. Use the labels that you attached during removal to connect the wire harness
leads to the solenoid coils on the manifold.
7. Check the hydraulic-fluid level in the hydraulic tank and add correct quantity
of fluid if necessary; refer to the Operator’s Manual .
8. Operate the machine functions slowly until air is out of system; refer to
Charging the Hydraulic System (page 6–151) .
Reelmaster ® 5410/5510/5610 Series Page 6–197 Hydraulic System: Service and Repairs
15216SL Rev C