Toro Reelmaster 5510 Series, Руководство по обслуживанию

Страница: 570 / 662

Inspecting the Reel Assembly
1. Inspect reel bearings to insure that they spin freely and have minimal axial
play.
2. inspect the reel shaft as follows. If reel damage is detected, replace reel.
A. Check the reel shaft for bending and distortion by placing the shaft ends
in V-blocks.
B. Check the reel blades for bending or cracking.
C. Check the service limit of the reel diameter; refer to (page ) .
3. Check the threaded inserts in the reel shaft for excessive wear or distortion.
Replace inserts if damage is evident.
A. One insert has LH threads and the other insert has RH threads. The
insert with LH threads has a groove on the insert face. A groove is cut in
the end of the reel shaft that has LH threads.
B. Use correct spline insert tool to remove threaded inserts; refer to (page ) .
Assembling the Cutting Reel (Cutting Unit with Aluminum Side Plates)
g230298
Figure 346
1. Reel shaft 2. Plastic plug (2 each)
1. If removed, install new plastic plugs into cutting reel shaft. Plugs should
be recessed into reel shaft from 34.8 to 41.4 mm (1.370 to 1.630 inches)
( Figure 346 ).
Note: One insert has LH threads and the other insert has RH threads. The
insert with LH threads has a groove on the insert face. A groove is cut in the
end of the reel shaft that has LH threads.
2. If previously removed, use correct spline insert tool to install threaded inserts;
refer to (page ) . Apply thread locking compound (Loctite #243 or equivalent)
to threaded portion of insert. Tighten threaded insert from 115 to 128 N∙m
(85 to 95 ft
‐‐‐
lb) .
3. Ensure that the 2 retaining rings are fully seated into the grooves on the
cutting reel shaft.
4. Carefully drive special washers onto reel shaft with tapered side of washers
toward reel (flat side toward bearing location). Installed washers should be
tight against retaining ring and should not wobble as the reel is rotated.
Cutting Unit: Service and Repairs Page 9–40 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C