Thermo Scientific Vanquish VH-P10-A-02, Руководство по эксплуатации

Страница: 68 / 238

5 • Installation
Page 68 Vanquish Pumps (VH-P10-A-02) Operating Manual
5. Place the solvent reservoirs in the solvent rack. Position the solvent
lines straight in the tubing guides.
6. Slide a filter holder onto each solvent line.
7. Fill the solvent reservoirs with solvent, observing the guidelines and
recommendations in the
Use of Solvents and Additives
section in this
manual.
Before using a solvent reservoir for the first time, rinse the
reservoirs thoroughly. Use a high-purity solvent for rinsing.
8. Tighten the reservoir caps hand-tight. Press the retaining guide into
the hole in the reservoir cap to ensure that the tubing is kept in
place in the cap.
9.
Optional – Required only if you want to install a shut off valve
a) Cut the solvent line near the reservoir cap with a tubing cutter.
Make sure that the cut is at a right angle to the length of the
line.
b) Onto the free end of each solvent line, slide a fitting and a
ferrule. Mind the correct orientation of the fitting and ferrule
(see picture).
c) Tighten the solvent lines to the shut off valve.
Figure 18: Installing a shut off valve in a solvent line
No. Description
1 Solvent line
2 Fitting
3 Ferrule
4 Shut off valve