TEXIO DL-2060, Инструкция по эксплуатации

Страница: 39 / 152

33
How to set Auto Zero
You can change the Auto Zero setting through the front panel or through the remote
interface operation.
Front Panel Operation
The following steps show how to set Auto Zero directly through the front panel.
Be aware of that Auto Zero setting is always affected by the resolution setting.
Whenever the resolution is altered, Auto Zero may be accordingly changed accordingly.
The relation between resolution and Auto Zero is shown in
Table 4-1 .
Press MENU and then ENTER on SET ADC. If “SET ADC” is not shown on the display, use
◁
and
▷
buttons to locate it. Press ENTER on ZERO Again, use
◁
and
▷
buttons to
locate it if it is not shown on the display. Press ENTER on AUTO ZERO option and then use
◁
and
▷
to the “ON” or “OFF”. Press “ENTER” by your choice. The locations of these
buttons are shown with red rectangle frames in Figure 4-1 .
Procedures: MENU
→
SET ADC
→
ZERO
→
AUTO ZERO {ON|OFF}
Table 4-1
Resolution
Auto
Zero Integration
Time(PLC)
Fast 4 ½ digits Off 0.02
Slow 4 ½ digits On 0.1
Fast 5 ½ digits Off 0.1
Slow 5 ½ digits On 1
Fast 6 ½ digits On 1
Slow 6 ½ digits On 10
※
Note: To change resolution, refer to Section 4.1.3: Resolution Setting in this chapter.