TECO F33 Series, Инструкция по эксплуатации, Страница: 40 / 192

Main Features 37
See Fig. 40. The Enable and Stop input must be active
continuously in order to accept any run-right or run-left
command. The last edge (RunR or RunL) is valid. Fig.
42 gives an example of a possible sequence.
Fig. 42 Input and output status for edge-control
7.3 Performing an
Identification Run
To get the optimum performance out of your VSD/
motor combination, the VSD must measure the electri-
cal parameters (resistance of stator winding, etc.) of
the connected motor. See menu [229], Motor ID-Run.
7.4 Using the Control Panel
Memory
Data can be copied from the VSD to the memory in the
control panel and vice versa. To copy all data (including
parameter set A-D and motor data) from the VSD to the
control panel, select Copy to CP[244], Copy to CP.
To copy data from the control panel to the VSD, enter
the menu [245], Load from CP and select what you
want to copy.
The memory in the control panel is useful in applica-
tions with VSDs without a control panel and in applica-
tions where several variable speed drives have the
same setup. It can also be used for temporary storage
of settings. Use a control panel to upload the settings
from one VSD and then move the control panel to
another VSD and download the settings.
Fig. 43 Copy and load parameters between VSD and control
panel
(06-F94new_1)
INPUTS
ENABLE
STOP
RUN R
RUN L
OUTPUT
STATUS
Right rotation
Left rotation
Standstill
NOTE: Load from and copy to the VSD is only possible
when the VSD is in stop mode.
VSD