Teac GX-1, Инструкция по эксплуатации

Страница: 110 / 122

Amplifiers
4-43
■
Settings
The following dialog box appears when you choose Setup and Params , and then
double-click the channel that you want to set.
Channel: Select IN to use this channel, or select DISABLE not to use
this channel.
Sample Frequency:
For multi-sampling, for each slot you can set a frequency that
is 10 times the Base Sample Freq.
Baud Rate:
Set the bit rate for the CAN bus line. To set detailed parame-
ters for the bus line, select the Set Detail check box and
click the Detail button. (See below.)
CAN ID: For the ID of the CAN data to be recorded, select Standard
or
Extended
.
Candb file:
When there is a CANdb file, specify the file.
Can Detail dialog box
SJW: Maximum bit cycle width
BRP: Baud rate pre-scaler
BSP: Sampling point
TS1: Time segment 1
TS2: Time segment 2
For details, see "Parameters on the CAN Detail Dialog Box".
▼
This amp does not support the listen-only mode.
So care is required because, if the Baud rate set-
ting differs from the Baud rate of the connected
bus, an error frame might be issued and the bus
for the sending node might be set to off
(released from the bus).