Teac GX-1, Инструкция по эксплуатации

Страница: 22 / 122

Installation
2-7
■
System Requirements for the PC
The recommended specifications of the PC are as follows.
· Operating system: Windows 95 (OSR2.0 or later),
Windows 98, or Windows NT 4.0
(
File sizes and the total number of files may be
limited depending on the operation systems.)
· CPU: Pentium 200 MHz or better
· Display resolution: At least 800 x 600 pixels
· Memory: At least 64 MB
· Hard disk: At least 2 GB
· SCSI interface: An Adaptec SCSI interface card (board)
must be used. Operations might be incorrect when using
another manufacturer's SCSI board.
■
Connections
●
SCSI cable
Prepare a half-pitch 50-pin cable.
●
Connecting the PC to the GX-1
Note:
Turn off the power to the GX-1 and PC before starting the con-
nection procedure. Do not turn on the power before completing
the connection procedure.
1.
Connect the SCSI cable to the SCSI connector at the rear of
the GX-1.
2.
Connect the other side of the SCSI cable to the connector of
the SCSI interface card (board).
●
Setting the SCSI ID
Set the SCSI ID using the DIP switches on the rear panel.
Three switches from the rightmost to the left in SW B corre-
spond to 2
0
, 2
1
, and 2
2
, respectively. (See the figure below.)
Set a number from 0 to 6. If one or more SCSI devices are
connected to the PC, make sure you set a unique ID. All the
digits are set to OFF at the factory.
Preparing a Personal Computer
■
Installing the Software
To install the provided software “GX Navi.”
1.
Insert the installation disk into the drive of the PC.
2.
Run Setup.exe on the installation disk. (The installer then
starts.)
3.
Follow the messages appearing in the setup wizard to pro-
ceed with the setup.
4.
When installation has finished, restart the PC.
■
Running the Software
Note: Exit software that eats a lot of memory before you run
the “GX Navi”.
To run “GX Navi”:
1.
Turn on the power at the GX-1 main unit: that is, toggle the
switch up to (
).
Note:
When the power is turned on, the signal conditioners are cali-
brated automatically. When the calibration finishes, a buzzer
sounds. (The buzzer consists of three pairs of beeps.) The time
until the buzzer sounds depends on the types of signal condi-
tioners that are mounted, and might take up to several minutes.
The buzzer will sound three pairs of beeps.
2.
Turn on the power to the PC.
3.
Start “GX Navi”.
Note:
While “GX Navi” is running, if the power to the GX-1 main
unit is turned off and an attempt is then made to perform some
operation with GX Navi, an error message is shown. If you
then turn on the power to the GX-1 main unit again, the PC will
be unable to recognize the GX-1. To enable the PC to recog-
nize the GX-1, restart GX Navi.
●
If startup time is unusually long
If the time between power-on and the buzzer sound is unusually
long, or if the buzzer sound is abnormal, the signal conditioners
may not be recognized. If the conditioners are not recognized,
turn off the power and then on again.
2
0
2
1
2
2
SW B