Teac GX-1, Инструкция по эксплуатации

Страница: 54 / 122

Explanations of Menus
3-27
●
About voice memo recording/playback
There are three types of modes for recording voice
memo:
MIX:
Voices are sampled at the same sampling frequency as
data. Set the sampling frequency to higher than 5 kHz
to listen to the voice. The voice data is appended to
the last channel data in the data file and is counted as
one data channel. Therefore, make sure that the value
[sampling frequency multiplied by (number of chan-
nels + 1)] does not exceed 3,200 k data/s. This voice
data can be converted into WAVE files with commer-
cially available software.
To play back the voice, select MIX.
BEFORE:
Voices are recorded before the start of recording and
cannot be recorded after that.
Voices are recorded from Rec Standby to Rec Start
for maximum of approximately four minutes. You
can start playing back voices by choosing File and
then Open. However, voice playback is stopped
when the Start button is clicked.
The voice data is recorded in a WAVE file created in
addition to a data file and a header file. When a data
file is copied, this WAVE file is also copied. The
WAVE files can be opened in Windows Media
Player.
AFTER:
Voices are recorded after the start of recording. In
Pre/PostTrigger recording, however, the timing is dif-
ferent, and the voices cannot be played back by
choosing File and then Open.
You cannot select this mode when recording to AIT.
The voice data is recorded in a WAVE file in the
same way as in the BEFORE mode.
Rec Standby Rec Start Stop
Data
Voice
Normal
PreTrigger
PostTrigger
Pre-time
Data
Data
max. 4 min.
Voice
max. 4 min.
Post-time
Voice
max. 4 min.
Rec Standby Rec Start Stop
Data
Voice
Normal
PreTrigger
PostTrigger
Pre-time
Data
Data
Post-time
Voice
Voice
Rec Standby Rec Start Stop
Data
Voice
Normal
PreTrigger
PostTrigger
Pre-time
Data
Data
Post-time
Voice
Voice