Teac GX-1, Инструкция по эксплуатации

Страница: 108 / 122

Amplifiers
4-41
■
Specifications
Number of channels : 2
Output format : Unbalanced
Output coupling : DC
Output range : ±1 to 5 Vp (variable in 0.1 V steps)
Zero shift : 0 to ±5 V (in 0.1 V steps)
Output current: Approx. 10 mA
Frequency response : DC to 80 kHz
Low pass filter : 2, 4, 8, 20, 40, 80, 200, 400, 800 Hz,
2 k, 4 k, 8 k, 20 k, 40 k, 80 kHz
–1.5 dB at the cutoff frequency (This value is derived
only from the AR-GXAO unit; The frequency response of
the coupled signal conditioner is added to this value.)
Attenuation: –48 dB/oct
Range accuracy: 2% (at temperatures of +23˚C±5˚C)
S/N ratio: 65 dB (output range: 5 V)
D/A converter : 16-bit
Output connector : BNC
■
Settings
The following dialog box appears when you choose
Setup
and
Params
, and then
double-click the channel that you want to set.
Analog Output Amp (AR-GXAO)
Output Range
: Select the output range.
Sample Frequency : Determined by Base Sample Freq in Params menu.
Channel Name : You can name the channel. Use up to 16 alphanumeric characters.
Output Slot : Select the slot of the channel you want to reproduce.
Offset Range
: Set the offset.
Cutoff Filter
: Select the output filter cutoff frequency.
Note: The output signals are filtered, but the displayed graphs are
not filtered.
All DA Amp Same Condition : When this option is selected, the same parameters
are set for all analog output amps.
▼
Analog output amplifiers must be installed in
the slots following the slots in which input
amplifiers are installed.
▼
The maximum output voltage is approx. ±6 Vp.
▼
Monitor output for recording signals can be
also output.
▼
The output ranges and the units cannot be
matched with the input settings depending on
the type of amplifiers.