Teac GX-1, Инструкция по эксплуатации

Страница: 49 / 122

Explanations of Menus
3-22
This chapter explains how to use the attached software “GX Navi” by explaining
each of the menu commands.
■
N e w
The New command enables you to select the destination to which new data is record-
ed, and to enter the name of the data file.
The File Menu
1.
Specify the media or the folder into which data is to be recorded. If the MO or PC
card contains no folder, enter an folder name in Directory Name . When speci-
fying a PC, you can also enter a directory in
Directory Name
.
2. Enter the filename. You can enter up to 5 alphanumeric characters. A 3-digit ID
number beginning from 001 is appended to these 5 characters, giving a total of 8
characters.
3.
Enter a comment using up to 80 alphanumeric characters. This is written to the
header file.
4. When Realtime is selected, the recorded data is transferred directly to the PC
media without going through the GX-1 internal memory—real-time transfer.
In real-time transfer, however, following functions are disabled:
• to monitor waveform displays, etc., on the PC
• to monitor elapsed time
• to attach an event mark
• to establish recording-standby status
• to operate with the remote controller ER-GXRC.
▼
When 4 or fewer characters are entered, zeros
(0) are embedded between the filename and the
3-digit number to give a total of 8 characters.
▼
No extension is needed. The .dat extension
will be attached to data files automatically, and
the .hdr extension will be appended to header
files.
▼
Real-time transfer is possible when the the
recording rate—sampling frequency multiplied
by number of channels—is 1500 k data/s or
lower.
▼
In real-time transfer, stop recording before the
PC’s hard disk space is less than 150 MB.
▼
When PC memory is small and cannot keep up
with the GX-1 transfer speed, recording stops
when the GX-1 memory becomes full. Data up
to that point is transferred.
5
1
2
3
4
▼
If you select GX-1’s MEMORY for the record-
ing media, transfer the data in the memory to
the PC after recording stop by choosing
Edit
and then Copy . When REC STANDBY is
established again after STOP , the data in the
memory will be cleared.