T-Comfort Comfort Pro S, Руководство по монтажу и пусконаладке

Страница: 75 / 200

73
Configuring the Comfort Pro S Configuration
Connection via Internet
The connection for remote configuration is established indirectly over the Internet. The connection session
starts with a voice call from one of the registered phone numbers. During the call, connection parameters (IP
address, keys) will be sent using a DTMF sequence. Afterwards, the Comfort Pro S communications system
establishes a secured SSH connection to an Internet server. The existing SSH connection allows to reverse-
connect to the Comfort Pro S communications system’s configurator. For this type of connection, the
Comfort Pro S communications system utilizes your Internet account. Establishing an SSH connection via this
Internet account must be allowed for this purpose.
The manual activation of the remote configuration activates the DTMF evaluation for the next voice call. You
can add additional phone numbers for remote configuration on the configurator’s Telephony: Extended:
Remote service menu page. Activate the IP option for the desired phone numbers.
Manual Activation
The following code number procedures activate or de-activate the remote configuration access. These code
digits can be entered on any standard terminal or system telephone.
Remote Configuration On (Log-on with Administrator Password)
H * 1 9 * Z
(system PIN)
#
Remote Configuration On (Log-on with Temporary Password)
H * 1 9 * Z
(system PIN)
* Z
(temporary password)
#
Remote Configuration Off
H # 1 9 #
S
Please note: The system PIN is preset to “0000” and it is absolutely imperative that
the system administrator changes it to prevent undesirable remote maintenance.
Using remote configuration, all Comfort Pro S settings with the exception of the system PIN can be edited or
updated. New software versions of the Comfort Pro S and the software for the connected system terminals
and base stations can also be installed (see the System: Firmware menu in the Configurator ).
For security reasons, settings in the Configurator , Network menu should only be edited on site to avoid
malfunctions or failures in the customer’s LAN (e.g. due to IP address conflicts). Refer to the chapter entitled
Configuration Examples starting on page 80, where interaction between the Comfort Pro S communications
system and a LAN is explained.