T-Comfort Comfort Pro S, Руководство по монтажу и пусконаладке

Страница: 37 / 200

35
Interface Cards Installation
2. To discharge, touch a radiator or another metallic installation connected to earth ground. Take the
interface card out of its packaging. Check that it is the correct type of card. There is a label specifying the
type on the connector.
Caution!
Static charges can damage the Comfort Pro S’s electronic components, so you must
provide potential equalisation between you and the system. Hold the edge of the
interface card with one hand. With the other hand briefly touch the capacitor on the
board.
3. Carefully plug the interface card into its designated slot. The label on the interface card’s connector must
be facing to the right.
Make sure it is sitting firmly in the slot.
4. Close the cover as far as the protection plate (see Opening and Closing Comfort Pro S starting on
page 30, steps 7 to 9). Connect the required connection cables to the relevant connection blocks (see
also Position of the Interfaces starting on page 38).
5. Close the cover of the device completely. Switch on the Comfort Pro S.
Comfort Pro S’s software can identify the type of interface card. After installation the interface card must be
individually configured before starting operations.
Once you have restarted Comfort Pro S you can view the interface cards’ status in der Web console. to do this,
call up the menu item Telephony: Ports: Slots . You will see a green tick in the Status column in the table next
to the slot’s number ( 1 or 2 ). The type of interface card must also be also shown in the hidden column.