T-Comfort Comfort Pro S, Руководство по монтажу и пусконаладке

Страница: 48 / 200

46
Installation Port Assignment, Termination, Cable Length
IAE = ISDN wall socket (German ISDN „Anschluss Einheit“)
If the S0 bus is coming from the Comfort Pro S leading to one or
more IAE sockets, the terminating resistors (“TR”) in the
Comfort Pro S and in the most distant IAE socket needs to be
switched on.
If the cabling of the S
0
bus is realized with two lines, outgoing from
the Comfort Pro S and leading to several IAE sockets, the terminating
resistors (“TR”) in both most distant IAE sockets needs to be
switched on. The terminating resistors in the Comfort Pro S must be
switched off. The S
0
bus should not be installed as star topology.
Sub-distributions are not allowed either.
Termination on an IAE socket: IAE sockets with built-in resistors are recommended,
because the terminating resistor can be switched on or off with a mechanical switch.
The figure shows how to mount resistors in an IAE socket without switchable resistors.
You can add S
0
ports by installing appropriate S
0
interface cards in a slot. These S
0
ports can be switched between internal and external operating modes.
Pressure terminals are used for internal and external S
0
ports. The connection
assignment of the pressure terminals changes when switched from internal to
external, as shown in the diagram above.
t
If, for example, you have connected an IAE socket to an internal S
0
port, and wish to
switch the S
0
port to external operating mode, you will need a crossover ISDN
connection cable to connect the IAE socket to an NTBA. The assignment of a
crossover connection cable is described in the chapter on PBX Networking under the
heading Direct Connection starting on page 122.
Line termination:
Enabled
IAE IAE IAE
Line termination:
Disabled
IAE IAE IAE
1a
1b
2a
2b
TR
TR
S
0
int
2a 2b 1a 1b
1 2 3 4 5 6 7 8
S
0
ext
1a 1b 2a 2b
1 2 3 4 5 6 7 8