0B-19 Maintenance and Lubrication:
5) After adjusting the play, check that the rear wheels
roll freely without applying the brake, the
transmission in neutral and the rear wheels off the
ground. Readjust the rear brake lever if the rear
wheels could not roll freely.
Rear Brake Friction Plate Wear Limit Inspection
B931H20206020
Replace rear brake friction plate
Every 10 000 km (6 000 miles)
After adjusted rear brake pedal and rear brake lever,
inspect the rear brake friction plate wear limit.
• While fully applying the rear brake, check to see that
the extension line of the index mark “A” is within the
limit “B”. If the extension line is out of the limit “B”,
replace the friction plates with new ones. Refer to
“Rear Brake Disassembly and Assembly: in
Section 4C”
.
CAUTION
!
Replace the friction plate as a set, otherwise
breaking performance will be adversely
affected.
Tire Inspection
B931H20206021
Inspect tire
Every 1 000 km (600 miles, 3 months)
Tire Tread Condition
Operating the vehicle with excessively worn tires will
decrease riding stability and consequently invite a
dangerous situation. It is highly recommended to replace
a tire when the remaining depth of tire tread reaches the
following specification.
Special tool
: 09900–20805 (Tire depth gauge)
Tire tread depth “a” (Service limit)
Front: 4.0 mm (0.16 in)
Rear: 4.0 mm (0.16 in)
Tire Pressure
If the tire pressure is too high or too low, steering will be
adversely affected and tire wear increased. Therefore,
maintain the correct tire pressure for good roadability or
longer tire life will result. Cold inflation tire pressure is as
follows.
Cold inflation tire pressure
Vehicle load capacity limit
172 kg (380 lbs)
CAUTION
!
To minimize the possibility of tire damage
from over-inflation, we strongly
recommended that a manual type air pump
be used rather than a high pressure air
compressor as found in service stations.
When filling air into the tires, never exceed 70
kPa (0.7 kgf/cm
2
, 10 psi)
CAUTION
!
The standard tire fitted on this vehicle is an
AT25 x 8-12
for the front and a AT25 x 10-
12
for the rear. The use of tires other than
those specified may cause instability. It is
highly recommended to use the specified
tires.
Tire type
DUNLOP
• Front: DUNLOP KT411
• Rear: DUNLOP KT415
“B”
“A”
I831G1020049-02
kPa
kgf/cm
2
psi
Front
35
0.35
5.1
Rear
30
0.30
4.4
“ a ”
I831G1020084-01
Содержание 2009 LT-A500XP
