Suzuki 2009 LT-A500XP, Руководство по обслуживанию

Страница: 420 / 624

3D-8 Propeller Shafts:
• Hold the transfer output driven gear with the special
tools and tighten the drive bevel gear nut (2) to the
specified torque.
CAUTION
!
The removed drive bevel gear nut must be
replaced with a new one.
Special tool
(A): 09920–53740 (Clutch sleeve hub holder)
(B): 09920–31020 (Extension handle)
Tightening torque
Rear output shaft drive bevel gear nut (a): 100
N·m (10.0 kgf-m, 72.5 lbf-ft)
• After the backlash and tooth contact have been
checked or adjusted, lock the drive bevel gear nut (2)
with a center punch. Refer to “Driven / Drive Bevel
Gear Shim Inspection and Adjustment (Page 3D-12)”.
Rear output shaft
• Install the rear output shaft (1).
NOTE
Be sure to fit the C-ring (2) and bearing
knock-pin “A” on the bearing to the groove of
the crankcase.
• After installed rear output shaft, check the backlash
and tooth contact. Refer to “Rear Output Shaft / Drive
Bevel Gear Removal and Installation (Page 3D-6)”.
Rear Output Shaft Disassembly and Assembly
B931H23406007
Refer to “Rear Output Shaft / Drive Bevel Gear Removal
and Installation (Page 3D-6)”.
Disassembly
1) Remove the circlips (1) from the universal joint.
2) Remove the bearings (2) by tapping with the special
tool.
Special tool
(A): 09913–70210 (Bearing installer set (10
– 75))
3) Remove the universal joint (3) along with the yoke
(4).
4) Remove the circlips (5).
5) Remove the bearings (6) by tapping with the special
tool.
Special tool
(A): 09913–70210 (Bearing installer set (10
– 75))
(A)
(B)
(a)
2
I931H1340031-01
“A”
2
1
I931H1340032-02
1
I931H1340033-01
2
4
3
(A)
I931H1340034-02