Suzuki 2009 LT-A500XP, Руководство по обслуживанию

Страница: 286 / 624

1I-13 Starting System:
Starter Idle Gear
Inspect the starter idle gear No. 1 (1) and No. 2 (2) for
wear or damage. If any damage is found, replace it with
a new one.
Starter Button Inspection
B931H21906017
Inspect the starter button in the following procedures:
1) Remove the left inner fender. Refer to “Front Side
Exterior Parts Removal and Installation: in
Section 9D”
.
2) Disconnect the handlebar switch coupler (1).
3) Measure the voltage between Y/G and O lead wires.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Diode test (
)
NOTE
If the tester reads 1.4 V and below when the
tester probes are not connected, replace its
battery.
Specifications
Service Data
B931H21907001
Unit: mm (in)
1
2
I931H1190035-01
Y/G
((+) probe)
O
((–) probe)
ON 0.4 – 0.6 V
OFF
1.4 V and more
(Tester’s battery voltage)
1
I931H1190036-01
Item Specification Note
Starter motor brush length
Standard 10 (0.39)
Limit 6.5 (0.26)
Starter torque limiter slip torque Standard
41.2 – 62.8 N
⋅
m
(4.2 – 6.4 kgf-m, 14.5 – 32.5 lbf-ft)
Starter relay resistance 3 – 5
Ω