Suzuki 2009 LT-A500XP, Руководство по обслуживанию, Страница: 312 / 624

2B-5 Front Suspension:
8) Disengage the tie-rod end (8) with the special tool.
WARNING
!
When using the tie-rod end remover, keep
clear of the tie-rod end because it may come
loose with some force and could strike you.
Special tool
(A): 09942–72410 (Tie-rod end remover)
9) Remove the cotter pins, knuckle end nuts and
washers.
10) Remove the steering knuckle end with a
commercially available bearing joint remover.
11) Remove the steering knuckle (11).
Installation
Install the steering knuckle in the reverse order of
removal. Pay attention to the following points:
• Clean up the steering knuckle end “A” and the mating
surface “B” of the steering knuckle.
NOTE
Make surfaces free from moisture, oil, dust
and other foreign materials.
• Apply grease to the lip of inner dust seal.
: Grease 99000–25160 (Water resistance
grease or equivalent)
• Install the washer (1) and tighten the knuckle end nuts
(2) to the specified torque.
Tightening torque
Steering knuckle end nut (a): 29 N·m (2.9 kgf-m,
21.0 lbf-ft)
8
(A)
I931H1220008-01
I931H1220009-01
I931H1220010-01
11
I931H1220011-03
“A”
“A”
“B”
“B”
I931H1220012-01