Suzuki 2009 LT-A500XP, Руководство по обслуживанию

Страница: 141 / 624

Engine General Information and Diagnosis: 1A-70
P0230-L (Use of SDS)
Specifications
Service Data
B931H21107001
Injector
FI S Secondary Throttle Valve Actuator
Step Action Yes No
1 1) Turn the ignition switch to OFF.
2) Remove the seat. Refer to “Front Side Exterior Parts
Removal and Installation: in Section 9D” .
3) Check the FP relay coupler for loose or poor contacts.
If OK, then check the FP relay. Refer to “Fuel Pump
Relay Inspection: in Section 1G” .
Is the FP relay OK?
• Y/Bl wire open or
poor “19” connection.
• O/W wire open or
shorted to ground.
• R/B or Y/R wire open
or shorted to ground
or poor “16”
connection.
• If wire and
connection are OK,
intermittent trouble or
faulty ECM.
• Recheck each
terminal and wire
harness for open
circuit and poor
connection.
• Replace the ECM
with a known good
one, and inspect it
again.
Replace the FP relay
with a new one.
I931H1110065-01
Item Specification Note
Injector resistance 11 – 13
Ω
at 20
°
C (68
°
F) —
Item Specification Note
CKP sensor resistance 170 – 250
Ω
CKP sensor peak voltage 5.0 V and more When cranking
IAP sensor input voltage 4.5 – 5.5 V
IAP sensor output voltage 1.78 – 3.35 V at idle speed
TP sensor input voltage 4.5 – 5.5 V
TP sensor output voltage
Closed 0.93 – 1.31 V
Opened 3.64 – 4.82 V
ECT sensor input voltage 4.5 – 5.5 V
ECT sensor output voltage 0.15 – 4.85 V
ECT sensor resistance Approx. 2.45 k
Ω
at 20
°
C (68
°
F)
IAT sensor input voltage 4.5 – 5.5 V
IAT sensor output voltage 1.88 – 3.06 V at 20
°
C (68
°
F)
IAT sensor resistance 2.22 – 3.22 k
Ω
at 20
°
C (68
°
F)
TO sensor resistance 19 – 20 k
Ω
TO sensor voltage
Normal 0.4 – 1.4 V
Leaning 3.7 – 4.4 V
When leaning
65
°
Injector voltage Battery voltage
Ignition coil primary peak voltage 80 V and more When cranking
ISC valve resistance Approx. 31 k
Ω
at 20
°
C (68
°
F)