Sun Microsystems StorEdge L400, Инструкция по установке и эксплуатации

Страница: 152 / 162

D-12 Sun StorEdge L400 Installation and User’s Guide • April 1998
D.2.3 Illegal Request—Sense Key 5h
TABLE D-5
lists the Illegal Request (5h) error conditions.
Note –
In
TABLE D-5
, the Command Descriptor Block (CDB) is the structure used to
communicate commands from an initiator to a target.
TABLE D-5
Illegal Request Sense Key (5h) ASC and ASCQ Values
ASC
Byte 12 ASCQ
Byte 13 Description
1Ah 00h The parameter list length was not valid.
20h 00h The operation code (OP code) for the Command Descriptor Block
(CDB) was invalid.
21h 01h An invalid element address was specified for the CDB.
24h 00h There were invalid fields in the CDB.
25h 00h The logical unit number specified in the Identify message or in the CDB
is not zero.
26h 02h There was an invalid field in the parameter list.
3Bh 0Dh The destination element was occupied for a MOVE MEDIUM
command.
3Bh 0Eh The source element was empty for a MOVE MEDIUM command.
3Bh 85h The destination for the MOVE MEDIUM command cannot be the CHM.
3Bh 86h The source for the MOVE MEDIUM command cannot be the CHM.
3Bh 87h A cartridge is stuck in the tape drive.
3Bh 90h The source cartridge is loaded inside the tape drive and is not
accessible.
3Dh 00h There were invalid bits in the identify message. Either one of the
reserved bits was nonzero or the LUNTAR field was nonzero.
3Fh 87h The tape library cannot execute a read or write firmware command.
The write firmware operation is in progress.
3Fh 88h The tape library cannot execute a read or write firmware command.
The read firmware operation is in progress.
53h 02h A media load or unload operation was prevented with a PREVENT/
ALLOW MEDIUM REMOVAL command.
80h 01h There was a cartridge in the grab base during power up, before a
cartridge move, or before a diagnostic test.