Sun Microsystems StorEdge L400, Инструкция по установке и эксплуатации

Страница: 148 / 162

D-8 Sun StorEdge L400 Installation and User’s Guide • April 1998
D.2 SCSI Sense Key Errors
The SCSI sense key error messages, listed in
TABLE D-2
, appear in the console
window on the computer system. Further descriptions of each SCSI Sense Key Error
are presented on the following pages.
TABLE D-2
SCSI Sense Key Error Messages
SCSI Sense Error
Messages Description Action
0h - No sense There is no specific sense key
information to report. N/A
2h - Not Ready The tape library cannot accept any
tape motion commands. Perform one or more of the following actions:
- Insert a data cartridge in the tape drive.
- Close the door.
- Put the tape library under SCSI control. To do
so, select SCSI Interface under the Control Mode
Menu.
4h - Hardware
Error The tape library detected a
nonrecoverable hardware failure
during a selftest or while performing
a command. Try the command again. If the error message
persists, replace the tape drive.
5h - Illegal Request The unit detected an illegal
operation request. For example, an
illegal parameter was sent with a
command or the tape library was in
the wrong mode to execute the
command. Retry the operation.
6h - Unit Attention Something happened that may have
changed the state of the unit. For
example, the unit was powered on, a
tape was loaded into the tape drive,
or the SCSI bus was reset. N/A
Bh - Aborted
Command The tape library aborted a command
(typically operator aborted). Retry the operation.