Sun Microsystems StorEdge L400, Инструкция по установке и эксплуатации

Страница: 102 / 162

7-16 Sun StorEdge L400 Installation and User’s Guide • April 1998
7.4.3.1 Self Test
The following actions occur during the
Self Test
diagnostic:
■
The gripper fingers of the CHM move to the home position.
■
The CHM cycles the long and short axes once, then moves to the home position at
the bottom of the long axis.
■
The spindle assembly is returned to home position.
1. Select the
Maintenance Menu
by pressing
↓
or
↑
,then
Enter
.
2. Select the
Diagnostics Menu
by pressing
↓
or
↑
, then
Enter
.
3. Select
Self Test
by pressing
↓
or
↑
, then
Enter
.
To abort the
Self Test
diagnostic, press
Escape
and
Enter
.
7.4.3.2 Position to Element Test
This diagnostic positions the CHM in front of a tape drive, cleaning cartridge slot, or
a particular slot in the cartridge holder.
Home CHM Moves the CHM to the park position, then to the opposite
end of the long axis.
Cycle Pick/Place Causes the CHM to take a cartridge from a specified slot
or CTS and replace it in the same slot. You must specify
the source slot (see TABLE 7-3) and the number of pick/
place cycles that the CHM should perform in increments
of 10 (up to 250).
Cycle Gripper Causes the gripper to open and close. You must specify
the number of cycles in increments of 10 (up to 250).
Cycle S Axis Causes the CHM to move end to end along the short axis
(the axis where the CHM moves in and out). You must
specify the number of cycles the CHM must perform in
increments of 10 (up to 250).
Cycle L Axis Causes the CHM to move end to end along the long axis.
You must specify the number of cycles the CHM must
perform in increments of 10 (up to 250).
Cycle Solenoid Cycles the door solenoid, used to lock the front door. You
must specify the number of cycles the CHM must
perform in increments of 10 (up to 250).
Cycle Drum Rotates the drum assembly 180 degrees.
TABLE 7-4
Diagnostic Menu Descriptions (Continued)