Sun Microsystems StorEdge L400, Инструкция по установке и эксплуатации

Страница: 151 / 162

Appendix D Error Codes D-11
40h 89h 77 The tape library was not in the correct control mode when the
command was executed.
To invoke commands from the Maintenance Menu, the tape
library must be in LCD Interface mode.
To run the SunDiag system exerciser, the tape library must be
in one of the Sequential modes (Sequential CTS1, Sequential
CTS2, or Dual Sequential).
Under normal operation, the tape library must be set to SCSI
Interface mode.
40h 90h 20 The gripper home sensor did not clear.
40h 91h 21 A gripper error occurred.
40h 92h 22 A gripper motion took longer than the maximum time
allocated for it. When motion functions do not complete in
the allocated time, current to the servo motors is cut off.
40h A0h 30 The CHM could not move along the short axis.
40h A2h 32 The motor on the short axis failed.
40h A3h 36 The tape library could not reset the servo chip for the short
axis.
40h A4h 37 The servo busy bit on the short axis failed.
40h A5h 73 The CHM could not reach its destination on the short axis.
40h B0h 40 The CHM could not move on the long axis.
40h B1h 41 The CHM could not return to home position on the long axis.
40h B2h 42 The motor on the long axis failed.
40h B3h 46 The tape library could not reset the servo chip for the long
axis.
40h B4h 47 The servo busy bit on the long axis failed.
40h B5h 70 The CHM could not reach its destination on the long axis.
40h E4h 99 One of the motors is stalled. The tape library must wait for it
to cool down before operations can resume.
40h E5h 76 The CHM could not reach its destination on the long axis.
40h 01h 17 There was a cartridge in the grab base during power up,
before a cartridge move, or before a diagnostic test.
840h 00h 75 Firmware error.
TABLE D-4
Hardware Error Sense Key (4h) ASC and ASCQ Values (Continued)
ASC
Byte 12 ASCQ
Byte 13 Display
Panel
Number
Description