Sun Microsystems StorEdge L400, Инструкция по установке и эксплуатации

Страница: 153 / 162

Appendix D Error Codes D-13
D.2.4 Unit Attention—Sense Key 6h
The tape library does not stack Unit Attention conditions. The tape library reports
only the last Unit Attention condition when there are two or more Unit Attention
conditions. A Unit Attention condition remains in effect for a particular initiator
until that initiator clears it.
TABLE D-6
lists combinations of ASC and ASCQ values for the Unit Attention sense
key (6h).
80h 03h The source cartridge magazine is not installed.
80h 04h The destination cartridge magazine is not installed.
80h 05h The source tape drive is not installed.
80h 06h The destination tape drive is not installed.
85h 01h The bar code scanner is not installed.
TABLE D-6
Unit Attention Sense Key (6h) ASC and ASCQ Values
ASC
Byte 12 ASCQ
Byte 13 Description
28h 00h The door was opened then closed.
28h 89h The tape library was placed in SCSI Interface mode after operating in
one of the serial port modes.
28h 8Dh The tape library was placed in SCSI Interface mode after operating in
LCD mode.
28h 8Eh The tape library was placed in SCSI Interface mode after operating in
one of the sequential modes (Sequential CTS1, Sequential CTS2, or Dual
Sequential).
29h 00h A power-on, SCSI bus reset, or device reset message occurred.
2Ah 01h Mode parameters have been changed. Issue a MODE SENSE (1Ah)
command to determine what the new mode parameters are.
3Fh 01h New microcode was loaded.
TABLE D-5
Illegal Request Sense Key (5h) ASC and ASCQ Values (Continued)
ASC
Byte 12 ASCQ
Byte 13 Description