Sun Microsystems StorEdge L400, Инструкция по установке и эксплуатации

Страница: 36 / 162

2-6 Sun StorEdge L400 Installation and User’s Guide • April 1998
2.3 Installing the Tape Cartridges
The next procedures discusses:
1. Preparing the tape cartridges
2. Placing them in the removable and fixed cartridge holders
3. Installing the removable cartridge holders into the tape library
2.3.1 Setting the Write-Protect Switch
Each 8 mm data cartridge has a write-protect switch. This switch determines
whether data can be written to the cartridge (write enabled) or whether data on the
cartridge is protected from being erased or overwritten (write protected). You can use
your finger or a ball-point pen to set the write-protect switch.
FIGURE 2-4
Setting the Write-Protect Switch
To write-protect a cartridge:
●
Move the write-protect switch away from the edge of the tape cartridge
(
FIGURE 2-4
).
If the red tab is visible, the cartridge is write protected.
To write-enable a cartridge:
● Move the write-protect switch toward the edge of the tape cartridge.
If the red tab is not visible, the cartridge is write enabled.