Sun Microsystems StorEdge L400, Инструкция по установке и эксплуатации

Страница: 149 / 162

Appendix D Error Codes D-9
D.2.1 Not Ready—Sense Key 2h
During a Not Ready condition, the tape library returns a Check Condition status in
response to each motion command until the Not Ready condition is removed.
During this time, the sense key is set to Not Ready and the ASC and ASCQ are set to
codes specifying that the tape library is not ready. All commands except tape motion
commands, perform normally.
TABLE D-3
lists Not Ready sense key (2h) error conditions.
D.2.2 Hardware Error—Sense Key 4h
The tape library returns a sense key of Hardware Error (4h) when a hardware-
related error occurs. After Hardware Error occurs, the tape library will not accept
motion commands. For each additional motion command, the tape library returns
the same Hardware Error. The tape library executes all other commands normally.
TABLE D-4
lists Hardware Error (4h) conditions. To determine the corrective actions
for the display panel numbers, see
TABLE D-1
.
TABLE D-3
Not Ready Sense Key (2h) ASC and ASCQ Values
ASC
Byte 12 ASCQ
Byte 13 Description
04h
01h The tape library is performing an initialization after a reset or the door
was closed.
83h The front door is open.
84h The tape library is executing ROM boot code and cannot execute the
command
89h The tape library is in 25-pin, 9-pin, or 4-pin serial port mode.
8Dh The tape library is in LCD Interface mode.
8Eh The tape library is in Sequential CTS1, Sequential CTS2, or Dual
Sequential modes.