Standard Horizon GX2400GPS, Руководство пользователя

Страница: 124 / 148

122
20 ATIS SETUP
The GX2400GPS/E supports the ATIS (Automatic Transmitter Identification
System) used in Inland waterways in Europe. When enabled ATIS mode
transmits a unique ATIS code each time the PTT switch is released at the end
of a transmission.
Users should check with their local marine regulatory authority in their country
for assistance in obtaining an ATIS code.
WARNING
The ATIS code can be inputted only once, please be careful not to input
the incorrect ATIS code. If the ATIS code needs to be reset, please contact
Standard Horizon to obtain the required reset code. Refer to section “
16.9.1
Reset the USER MMSI and ATIS CODE
”.
20.1 ATIS CODE PROGRAMMING
1.
Press & hold [
]

“ ATIS SETUP ”

“ ATIS CODE ”
2. Press the [◄] or [►] key to select the first number of
your ATIS, then press the [ SELECT ] soft key to step
to th e next number.
3. Repeat step 2 to set the ten digits of the ATIS.
4. If a mistake is made in entering the ATIS, press the [◄]
or [►] key to select “←” or “→”, press the [ SELECT ]
soft key until the incorrect number is selected, then
perform step 2.
5. When entering the number is complete, press the
[
FINISH
] soft key. The Radio will ask you to input the
ATIS number again. Perform steps 2 through 4 above.
6. After the number has been entered twice, press the
[
FINISH
] soft key to store the ATIS number in memory.
7. Press the [ OK ] soft key to ret urn to radio operation.