Standard Horizon GX2400GPS, Руководство пользователя

Страница: 120 / 148

118
NOTE
• Data output will be performed according to the data acquisition priority
order setting of “ORDER OF PRIORITY”. Refer to section “ 19.1 ORDER
OF PRIORITY ” for details.
• When “UNIT POWER” of “OPTION GPS UNIT” is set to OFF, NMEA sentences
will not be output. (OPTION GPS reception data will be output as is.)
• The output interval of each NMEA sentence depends on the output timing
on the input device. However, sentences which include POS data will be
output at intervals of two seconds or less.
• When all sentences are set to be output, depending on the baud rate, not
all sentences can be output at intervals of one second or less. GSA and
GSV sentences will be output at intervals of around five seconds.
19.10 INTERNAL GPS UNIT
Change the internal GPS receiver settings. (The settings in this section are
also valid when connecting the SCU-38 External GPS Antenna to the internal
GPS receiver.)
19.10.1 Position Data Output
Select the connection device to be used when outputting position data.
1.
Press & hold [
]

“ GPS SETUP ”

“ INTERNAL GPS UNIT ”
2. Rotate the
DIAL/ENT
knob to select “
POS DATA
OUTPUT ”, then press the [ SELECT ] soft key.
3. Rotate the DIAL/ENT knob to select “ NMEA 2000 ” or
“ NMEA 0183 ”, then press the [ SELECT ] soft key.
4. Rotate the DIAL/ENT knob to select “ OFF ” or “ ON ”.
5. Press the [ ENTER ] soft key to store the new setting.
6. Press the [ CLEAR ] key to return to radio operation.