Siemens siprotec SJ62, Руководство пользователя

Страница: 369 / 715

3 Mounting and Commissioning
367
SIPROTEC 4, 7SJ62/63/64 Handbuch
C53000-G1140-C147-A, Edition 07.2015
With 7SJ64 and single-phase voltage transformer connection the voltage connected
to voltage input V
4
is always interpreted as the voltage which is to be synchronized.
Binary Inputs and
Outputs for
7SJ62/63/64 The configuration of the binary in- and outputs, i.e. the individual adaptation to the
plant conditions, is described in the SIPROTEC 4 System Description. The connec-
tions to the plant are dependent on this actual configuration. The presettings of the
device are listed in Appendix A, Section A.5. Check also whether the labelling corre-
sponds to the allocated annunciation functions.
Changing Setting
Groups If binary inputs are used to switch setting groups, please observe the following:
• Two binary inputs must be dedicated to the purpose of changing setting groups
when four groups are to be switched. One binary input must be set for
„>Set
Group Bit0“
, the other input for
„>Set Group Bit1“
. If either of these input
functions is not assigned, then it is considered as not controlled.
• To control two setting groups, one binary input set for
„>Set Group Bit0“
is suf-
ficient since the binary input
„>Set Group Bit1“
, which is not assigned, is con-
sidered to be not controlled.
• The status of the signals controlling the binary inputs to activate a particular setting
group must remain constant as long as that particular group is to remain active.
The following table shows the allocation of the binary inputs to the setting groups A to
D and a simplified connection diagram for the two binary inputs is illustrated in the fol-
lowing figure. The figure illustrates an example in which both Set Group Bits 0 and 1
are configured to be controlled (actuated) when the associated binary input is ener-
gized (high).
Where:
no = not energized or not connected
yes = energized
Table 3-1 Changing setting groups using binary inputs
Figure 3-1 Connection diagram (example) for setting group switching using binary inputs
Binary Input Active Group
>Set Group Bit
0
>Set Group Bit
1
No No Group A
Yes No Group B
No Yes Group C
Yes Yes Group D