Siemens SINUMERIK 828D Turning, Руководство по эксплуатации функций

Страница: 1517 / 1799

W1: Tool offset
18.6 Toolholder with orientation capability
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
1517
New tool or new toolholder
When a new tool is activated, it is always treated as if it was mounted on the active toolholder.
A new toolholder is activated immediately when it is programmed. It is not necessary to change tools or
reprogram the active tool. The toolholder (number) and tool (number) are independent and can be used in any
combination.
Toolholder from G code of group 42
Absolute tool orientation
TCOABS
(Tool Carrier Orientation ABSolute):
Tool orientation is determined explicitly if the corresponding values are entered in system variable $TC_CARR13
or $TC_CARR14 and G code
TCOABS
is activated in G-code group 42.
Frame tool orientation
TCOFR
(Tool Carrier Orientation FRame):
Tool orientation can also be determined automatically from the current orientation of an active frame when
selecting a tool, if one of the following G codes is active in G-code group 42 when the toolholder is selected:
•
TCOFR
or
TCOFRZ
The toolholder with orientation capability is set so that the tool points in the Z direction.
• TCOFRX
The toolholder with orientation capability is set so that the tool points in the X direction.
• TCOFRY
The toolholder with orientation capability is set so that the tool points in the Y direction.
The effect of
TCOFR
is such that, when machining on an inclined surface, tool compensations are considered
implicitly as if the tool were standing vertically on the surface.
Note
The tool orientation is not bound strictly to the frame orientation. When a frame is active and
G code
TCOABS
is active, you can select a tool, whereby the orientation of the tool is
independent of the orientation of the active frame.
Following tool selection, you can change the frame, which does not affect the components of
tool length compensation. It is then no longer certain that the tool is positioned perpendicular
to the machining plane. You should therefore first check that the intended tool orientation is
maintained on an inclined surface.
When
TCOFR
, etc., is active, the tool orientation used in the tool length calculation is always
determined from the active frame each time the toolholder is changed.