Siemens SINUMERIK 828D Turning, Руководство по эксплуатации функций

Страница: 786 / 1799

K2: Axis Types, Coordinate Systems, Frames
10.5 Frames
Basic Functions
786
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
In workpiece drawings, oblique surfaces are frequently described by way of solid angles, i.e. the angles, which
the intersection lines of the oblique plane form with the main planes (X-Y, Y-Z, Z-X planes) (see figure). The
machine operator is not expected to convert these solid angles into the angles of rotation of a chaining of
individual rotations.
For this reason, the language commands
ROTS
,
AROTS
and
CROTS
are used, with which the rotations can be
immediately described as solid angles.
The orientation of a plane in space is defined unambiguously by specifying two solid angles. The third solid angle
is derived from the first two. Therefore, a maximum of 2 solid angles may be programmed, e.g. in the form
ROTS
X10 Y15
. If a third solid angle is specified, an alarm will be triggered.
It is permissible to specify a single solid angle. The rotations which are performed with
ROTS
or
AROTS
in this
case are identical to those for
ROT
and
AROT
.
An expansion of the existing functionality arises only in cases where exactly two solid angles are programmed.
The two programmed axes define a plane, the non-programmed axis defines the related third axis of a right-hand
coordinate system. Which axis is first and which second is then unambiguously defined for both programmed
axes (the definition corresponds to those found in the plane definition of
G17/G18/G19
). The angle programmed
with the axis letter of an axis of the plane then specifies the axis, around which the other axis of the plane must
be rotated in order to move this into the line of intersection, which the rotated plane forms with the plane
surrounded by the other and the third axis. This definition ensures that, in the case that one of the two
programmed angles is towards zero, the defined plane enters the plane, which is created if only one axis is
programmed (e.g. with
ROT
or
AROT
).
The diagram shows an example where X and Y are programmed. Y here gives the angle, by which the X axis
must rotate around the Y axis to bring the X axis to the line of intersection formed by the oblique plane and the
X­Z plane. The same principle applies for the programmed value of X.
The specification of the solid angle does not define the orientation of the two­dimensional coordinate system
within the plane (i.e. the angle of rotation around the surface normal vector). The position of the coordinate
system is thus determined so that the rotated first axis lies in the plane, which is surrounded by the first and third
axes of the non­rotated coordinate system.
This means that
Note
In the shown position of the oblique plane the value of Y is positive, that of X on the other
hand negative.
\
[
]
\
[
2EOLTXHSODQH