Siemens SINUMERIK 828D Turning, Руководство по эксплуатации функций

Страница: 1496 / 1799

W1: Tool offset
18.5 Tool radius compensation 2D (TRC)
Basic Functions
1496
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
End point behind contour
If the end point is behind the contour, a circle or straight line is always inserted depending on
G450
/
G451
. In this
case,
G460
-
G462
has no effect.
If, in this situation, the last traversing block has no intersection with a preceding block, an intersection with the
inserted contour element or with the linear section from the end point of the circumnavigation circle to the
programmed end point can result.
If the inserted contour element is a circle (
G450
), and it intersects with the preceding block, this is the same as
the intersection, which would be produced with
NORM
and
G461
. In general, however, a remaining section of the
circle still has to be traversed. An intersection calculation is no longer required for the linear section of the
retraction block.
In the second case (if no intersection is found between the inserted contour element and the preceding blocks),
the intersection between the retraction straight line and a preceding block is approached.
Therefore, when
G461
or
G462
is active, behavior deviating from
G460
can only arise if
NORM
is active or if
behavior with
KONT
is identical to
NORM
due to the geometrical conditions.
Example:
Program for using
G461
during approach:
Note
The approach behavior is symmetrical to the retraction behavior.
The approach/retraction behavior is determined by the state of the G command in the
approach/retraction block. The approach behavior can therefore be set independently of the
retraction behavior.
N10 $TC_DP1[1,1]=120 ; Tool type mill
N20 $TC_DP6[1,1]=10 ; Radius
N30 X0 Y0 F10000 T1 D1
N40 Y20
N50 G42 X50 Y5 G461
N60 Y0 F600
N70 X30
N80 X20 Y-5
N90 X0 Y0 G40
N100 M30