Siemens SINUMERIK 808D, Руководство по диагностике

Страница: 76 / 566

Explanation: The backup file for automatic memory reconfiguration could not be read
Reaction: Alarm display.
Remedy: Please inform the authorized personnel/service department.
Programm
continuation:
Switch control OFF - ON.
4502 [Channel %1: ] Anachronism %2(%3) -> %4
Parameters: %1 = Channel number
%2 = String: MD identifier
%3 = String: MD identifier
%4 = String: MD identifier
Explanation: Previously, in MD20110 $MC_RESET_MODE_MASK Bit4 and Bit5, the reset behavior of the 6th or 8th G groupe was
determined. This setting is now made in MD20152 $MC_GCODE_RESET_MODE.
In order to ensure compatible handling of "old" data backups, the "old" values are taken from MD20110
$MC_RESET_MODE_MASK and entered in MD20152 $MC_GCODE_RESET_MODE.
Reaction: Alarm display.
Remedy: --
Programm
continuation:
Clear alarm with the Delete key or NC START.
4503 [TO unit %1: ] H number %2 assigned more than once. Machine data is not set.
Parameters: %1 = TO unit
%2 = H number
Explanation: This error can only occur if MD10880 $MN_MM_EXTERN_CNC_SYSTEM= 1 or 2. MD10890,
$MN_EXTERN_TOOLPROG_MODE bit 3 is reset (this MD becomes effective at power-on). On checking data
management, it was found that various edges of the same TO unit had the same H number. MD10890
$MN_EXTERN_TOOLPROG_MODE bit 3 remains set and is not included in data management.
Reaction: Alarm display.
Remedy: H numbers must be assigned only once in a TO unit. Then, MD10890, $MN_EXTERN_TOOLPROG_MODE, bit 3 can be
set = 0 and a restart can be performed.
Programm
continuation:
Clear alarm with the Delete key or NC START.
4600 Invalid handwheel type for handwheel %1
Parameters: %1 = Handwheel number
Explanation: The handwheel type (hardware segment) for handwheel %1 requested through MD11350 $MN_HANDWHEEL_SEGMENT
is invalid.
Reaction: Interface signals are set.
Alarm display.
Remedy: Configure a valid type for the corresponding handwheel through MD11350 $MN_HANDWHEEL_SEGMENT.
Programm
continuation:
Switch control OFF - ON.
4610 Invalid handwheel module for handwheel %1
Parameters: %1 = Handwheel module
Explanation: For SINUMERIK 840D and SINUMERIK 840DI only:
The handwheel module for handwheel %1 requested through MD11351 $MN_HANDWHEEL_MODULE is not available
for 840D systems. An 840D system is always regarded as a module. Therefore MD11351 $MN_HANDWHEEL_MODULE
= 1 must always be set for handwheels directly linked to 840D systems.
Reaction: Interface signals are set.
Alarm display.
Remedy: Set machine date MD11351 $MN_HANDWHEEL_MODULE = 1 for the corresponding handwheel.
SINUMERIK 808D ADVANCED alarms
5.2 NCK alarms
Diagnostics Manual
76
Diagnostics Manual, 06/2015, 6FC5398-6DP10-0BA2