Siemens HydroRanger 200 HMI, Руководство по эксплуатации

Страница: 52 / 404

Commissioning
6.2 Activating the device
HydroRanger 200 HMI
50
Operating Instructions, 06/2018, A5E36281317-AC
6.2 Activating the device
● The device has two modes of operation: RUN and PROGRAM.
● While the device is in PROGRAM mode, outputs are de-activated and the device does
not measure the process.
● To enter PROGRAM mode using the device local push buttons, press . Press to
return to Measurement mode.
● The display will return to Measurement mode after ten minutes of inactivity (from last
button press), when in PROGRAM mode and from within a Wizard. Pressing will then
take you to the main navigation menu. (It will not return to the screen from which the
timeout occurred.)
6.3 RUN mode
In RUN mode, the device detects material level and provides control functions. The device
automatically starts in RUN mode when power is applied.
System status is shown on the display, or on a remote communications terminal.
Measurement views in RUN mode
The device provides two measurement views:
● Measurement View 1 displays the Primary Reading
● Measurement View 2 displays both the Primary Reading and the Auxiliary Reading.
When the device is in RUN mode, you can switch between these views using the and
arrow keys.
The value displayed in Primary Reading is determined by parameter Sensor mode (2.1.3.)
(Page 163). On the other hand, the value displayed in Auxiliary Reading is preset when you
adjust Sensor mode (2.1.3.) (Page 163), although you can change the selection later using
Default auxiliary reading (2.12.7.) (Page 239).