LISST-Holo2
User’s Guide
47
5. Close the browser and other running programs and
restart the computer.
6. Connect to the LISST-Holo2 wireless network and
open the browser. In the address bar enter
www.routerlogin.net
. You may be prompted for a
Username and password. Use
admin
and
password
. The NETGEAR genie screen should
appear. Click on the Advanced tab and verify that
the IP address in the Router Information box is set
to the desired value
8.3 Changing the LISST-HOLO2 IP address
To change the IP address of the LISST-HOLO2 use the
web interface.
Connect as described in section 3.2 and go to the Tools
page of the LISST-HOLO2 web interface.
Scroll down until you get to Network Parameters.
Change the IP address to the desired address and click
the Apply button. The changes will take effect
immediately, so you will need to enter the new IP
address in your browser to continue working with the
LISST-HOLO2
8.4 Recovering Lost IP Address Using the Serial Port
In order to communicate with the LISST-Holo2 through
the web interface, you must know the IP address of the
instrument.
If you do not remember the IP address if your
instrument, you can look up the IP address using the
instrument serial port.
Connect the power cable to the 5-pin connector on the
LISST-Holo2. Plug the USB end of the cable into your
computer. You may need to wait a few minutes for your
computer to install the USB to serial adapter driver.
If the LISST-Holo2 is not already awake, toggle the
magnetic switch to the one position, then back to zero
position to wake the instrument.
Connect to the LISST-Holo2 using a terminal program
(e.g. HyperTermal, TeraTerm). Connect to the
instrument using the settings shown on the left,
however, change the ‘Port’ field to the appropriate port
on your computer.
Содержание LISST-Holo2
Страница 2: ......