Sequoia LISST-Holo2, Руководство пользователя

Страница: 32 / 57

32 LISST-Holo2
User’s Guide
After connecting the Battery Charger to the LISST-Holo2 and connecting to AC
power the charger will initialize and evaluate the battery before charging will being.
This takes about 5 to 10 seconds. During this time, the LED will be a mix of red
and green before turning to either solid red or green.
Observe the charger LED to confirm that it turns red, indicating the start of
normal fast charging.
•
If fast charging does not start, check that the vent is open.
•
If the vent is open but fast charging still doesn’t start, also connect
the external power supply through the 5-pin bulkhead connector
(this
is necessary when the batteries are so deeply discharged that the battery
supervisor electronics have turned off)
Charge times vary depending upon the state of charge in the battery. Fully
depleted batteries will take about 6 hours to charge. Do not leave the charger
connected longer than 12 hours.
Fully-closed vent
When the charge is complete, remove the charger and close the vent completely,
as shown at left. The vent should be screwed down till it is finger tight.
Do not use
any tools to tighten the v ent . Over-tightening can break the plastic part and
cause leakage into the housing.