Segway SE-3 Patroller, Руководство по обслуживанию

Страница: 78 / 148

SE-3 Patroller
70
UI Module
The UI Module is how the user interacts with the SE-3 Patroller.
NOTICE
The fault history is stored in the UI Module. Replacing the UI
Module will essentially “reset” the fault history.
Tools Required: 4 mm hex wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the Battery Module ( page 8 ).
3. Using a 4 mm hex wrench, remove the four fasteners
as shown in Figure 99 .
4. Disconnect the harness as shown in Figure 100 .
5. Remove the UI Module.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Connect the harness as shown in Figure 100 .
3. Using a 4 mm hex wrench, install the four fasteners
as shown in Figure 99 .
Torque to 1.8 N-m (1.3 ft-lbf) .
4. Install the Battery Module ( page 8 ).
5. Perform post-service tests ( page 127 ).
UI Module
(24088-00001)
24409-00003
1.8 N-m (1.3 ft-lbf)
Figure 99: UI Module
Figure 100: UI Harness
Controls