Segway SE-3 Patroller, Руководство по обслуживанию

Страница: 48 / 148

SE-3 Patroller
40
Brake Light
Tools Required: 3 mm hex wrench
7 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Reach into the wheel well and disconnect the Brake
Light harness. See Figure 54 .
3. Use a 7 mm socket wrench, remove the lock nut and
P-clip on the back of the Brake Light. See Figure 52 .
4. Using a 3 mm hex wrench, remove the two Brake
Light fasteners. See Figure 51 .
5. Remove the Brake Light.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Feed the Brake Light harness through the hole in the
Fender.
3. Reach into the wheel well and connect the harness.
4. Slide the plastic sleeves onto the fasteners, then
install the fasteners and ( Figure 51 ).
5. Using a 3 mm hex wrench, tighten the fasteners.
Torque to 1.0 N-m (0.74 ft-lbf) .
CAUTION!
Do not overtighten. Overtightening may damage the
rubber seal around the light.
6. Install a P-clip around the pigtails from both the
Brake Light and Directional Light (see Figure 52 ).
Slide the P-clip onto the upper Brake Light fastener.
7. Using a 7 mm socket wrench, install a lock nut to hold
the P-clip in place.
Torque to
1.6 N-m (1.2 ft-lbf) .
8. Perform post-service tests ( page 127 ).
Figure 51: Brake Light
24315-00008
1.0 N-m (0.74 ft-lbf)
Brake Light
(24254-00001)
Figure 52: Tail Light Harnesses
Lights
P-Clip
(24346-00001)
23202-00001
1.6 N-m (1.2 ft-lbf)