Segway SE-3 Patroller, Руководство по обслуживанию

Страница: 53 / 148

Service Manual
45
Battery Bumpers
The Battery Bumpers position the Battery Module at the
correct distance from the frame so that there is a good
connection between the Battery Module and the PI Board.
Tools Required: 4 mm hex wrench
8 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module ( page 8 )
b. Front Fender ( page 24 )
c. Front Splash Guard ( page 25 )
d. Front Fender Bracket ( page 98 )
e. Main Splash Guard ( page 26 )
3. Using an 8 mm socket wrench, remove the lock nuts
holding the three brake line P-Clips to the front of the
frame. See
Figure 59 .
4. Slide the P-Clips off the threaded studs.
5. Using a 4 mm hex wrench, remove the Battery
Bumpers. See Figure 60 .
NOTICE
Keep track of how many washers go with each
bumper. Bumper alignment is critical for maintaining
a solid battery connection. Because of variations
in the frame, different SE-3 Patrollers may have
different quantities of washers installed with the
bumpers.
Figure 59: Brake Line P-Clips
Figure 60: Battery Bumpers
Battery Bumpers
(23948-00001)
Battery Compartment
23202-00003
1.4 N-m (1.0 ft-lbf)