Segway SE-3 Patroller, Руководство по обслуживанию

Страница: 72 / 148

SE-3 Patroller
64
Front Brake Line
Replacing the Front Brake Line can be a messy job. Be careful
not to let any brake fluid get on the harnesses, electronics, or
rotor. Immediately wipe up any spilled brake fluid with a shop
towel.
Tools Required: 2.5 mm hex wrench
14 mm socket wrench
Wire cutters
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the following components:
a. Battery Module ( page 8 )
b. Storage Trays ( page 13 )
c. Bib Panel ( page 14 )
d. Glove Box ( page 16 )
e. Front Cowl ( page 17 )
f. Light Cluster ( page 18 )
g. Front Fender ( page 24 )
3. Drain the brake fluid out of the front brake line
(see page 53 ).
4. Using a 14 mm socket wrench, disconnect the Banjo
Bolt from the Caliper. See Figure 93 .
NOTICE
Place the Banjo Bolt in a container to catch any brake
fluid that drains out.
5. Using a 2.5 mm hex wrench, remove the three
P-Clips. See Figure 92 .
6. Using wire cutters, remove the cable tie on the
steering column. See Figure 92 .
7. Using a 14 mm socket wrench, disconnect the Banjo
Bolt from the Master Cylinder. See Figure 78 .
8. Remove the brake line.
Figure 92: Front Brake Line
Brakes
Cable tie
P-Clips
2.5 N-m (1.8 ft-lbf)
P-Clip
Front Brake Line
23955-00001