Segway SE-3 Patroller, Руководство по обслуживанию

Страница: 113 / 148

Service Manual
105
Maximum Speed
You can set the maximum speed of the SE-3 Patroller by using
a DIP switch located on the PI Board.
Tools Required: None
Procedure
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Remove the Battery Module ( page 8 ).
WARNING!
Wait 2 minutes after removing the Battery Module
before touching the PI Board. This is how long it takes
for the capacitors on the PI Board to self-discharge.
Touching the PI Board before the capacitors have
fully discharged could result in electric shock.
3. Ajust the DIP switch. See Table 3 .
4. Install the Battery Module ( page 8 ).
Validation
1. Bring the SE-3 Patroller to a large open space, such
as an empty parking lot.
2. Drive the SE-3 Patroller until it reaches maximum
speed.
3. Look at the speedometer. Verify that the displayed
speed is the desired maximum speed.
Figure 143: DIP Switch
Switch 1
Left Left Right Right
Switch 2
Left Right Left Right
Max. Speed
8 mph 10 mph 12.5 mph 15 mph
Table 3: DIP Switch Settings
Power Interface