Segway SE-3 Patroller, Руководство по обслуживанию

Страница: 46 / 148

SE-3 Patroller
38
Side Strobe Light
Tools Required: 3 mm hex wrench
7 mm socket wrench
Torque wrench
Removal
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Access the Light Cluster by following the instructions
to Remove Body Panels on page 36 .
3. Disconnect the wire harness.
4. Using a 3 mm hex wrench and a 7 mm socket wrench,
remove the two fasteners securing the light.
See
Figure 47 .
5. Remove the light.
Installation
1. Make sure the SE-3 Patroller is powered off,
unplugged, and the parking brake is engaged.
2. Feed the wire harness through the hole in the Light
Cluster and connect it to the Front Light Harness.
3. Orient the light. The pigtail is offset where it connects
with the light. Orient the lights so the pigtail is toward
the top on one light and toward the bottom on the
other light. See
Figure 48 .
4. Slide the plastic sleeves onto the fasteners, then
install the fasteners and lock nuts ( Figure 47 ).
5. Using a 3 mm hex wrench and a 7 mm socket wrench,
tighten the fasteners.
Torque to
1.6 N-m (1.2 ft-lbf) .
CAUTION!
Do not overtighten. Overtightening may damage the
rubber seal around the light.
6. Reassemble the SE-3 Patroller by following the
instructions to Install Body Panels on page 36 .
7. Perform post-service tests ( page 127 ).
Figure 47: Side Strobe Lights
23202-00001
1.6 N-m (1.2 ft-lbf)
24315-00007
Side Strobe Light
Police 24253-00002
Security 24253-00003
Figure 48: Harness Offset
Pigtail is offset
toward the top
Lights