Scientific
SMO1000E
96/185
10 Address & Data
— the oscilloscope will be triggered when the following
conditions are satisfied.
The address’s length must be 10 bits and the address’s value is the same as set
value.
If you have set either Data1’s or Data2’s value, and the signal has a data is the same
as that value. If you have set both Data1’s and Data2’s value, the signal should has
two consecutive data, the first data’s value is Data1, second data value is Data2.
(
Note
: If the set value is 0xXX, any data value will be matched)
Figure 39
Data Length
— When SDA data’s length is equal to the value of Byte Length and
address’s length is the same as set value, the oscilloscope will be triggered. Byte
length is in the range of 1 to 12 bits.
Operation steps:
1. Press
Setup
to enter the
TRIGGER
function menu.
2. Press
Type
and select
Serial
.
3. Press
Protocol
and select
I2C
.
4. Press
Trigger Setting
softkey.
Содержание SMO1000E
